Publicité
Les langues disponibles
Les langues disponibles
SAFETY
This section contains information and important notices for safe commissioning and handling of
machine.
For your own safety, read these operating instructions carefully before putting the
machine into operation. This will enable you to handle the machine safely and
prevent misunderstandings as well as possible damage to property and persons. Also
observe the symbols and pictograms used as well as the safety instructions and
hazard warnings!
13.1
Intended use of the machine
The machine is intended exclusively for the following activities:
The planing (wide and narrow side as well as chamfering of the edges of a workpiece) and
thickness planing of sawn timber within the specified machine limits.
HOLZMANN MASCHINEN GmbH assumes no responsibility or warranty for any other
use or use beyond this and for any resulting damage to property or injury.
13.1.1
Technical Restrictions
The machine is intended for use under the following ambient conditions:
Relative humidity:
Temperature (for operation)
Temperature (for storage and/or transport)
13.1.2
Prohibited Use / Forseeable Misuse
-
Operation of the machine without adequate physical and mental aptitude
-
Operating the machine without knowledge of the operating instructions
-
Changes in the design of the machine
-
Operating the machine under explosive conditions
-
Operating the machine in closed rooms without chip and dust extraction device (a normal
household vacuum cleaner is not suitable as an extraction device)
-
Operating the machine outside the specified power range
-
Remove the safety markings attached to the machine.
-
Modify, circumvent or disable the safety devices of the machine.
-
Machining of materials with dimensions outside the limits specified in this manual.
-
Use of tools that do not meet the safety requirements of the standard for woodworking
machine tools (EN847-1).
-
Removal of the blade guard during planing.
-
Synchronous planing
-
Application work (workpiece only machined over a partial length)
-
Planing of strongly curved workpieces
The prohibited/hazardous use or disregard of the information and instructions presented in
this manual will result in the voiding of all warranty and damage claims against Holzmann
Maschinen GmbH.
13.2
User requirements
The machine is designed to be operated by one person. The prerequisites for operating the
machine are physical and mental fitness as well as knowledge and understanding of the operating
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O TE
max. 65 %
+5° C to +40° C
-20° C to +55° C
HOB305PROSMW2_230V | HOB305PROSMW2_400V
SAFETY
31
Publicité
