Publicité
Les langues disponibles
Les langues disponibles
OPERATION MORTISING UNIT (OPTIONAL)
• Assembly see HOB305PROLL
• Clamp the milling tool required for drill chuck (1) of the planer shaft
• Lay up the workpiece on the mortising table (2)
• Tilt the downholder (3) to the middle of the workpiece
• Push the lever of the downholder down to clamp the workpiece
• Loosen the locking screw (4) and adjust the table height with the handwheel (5) to the
requested height of the milling tool
• Adjust the horizontal travel of the table with both set screws (6)
• Start the machine (see operation planer and thicknesser)
• Move the table with the operating lever (8) in left direction to the limiter
• Press down the workpiece carefully on the milling tool and up to max. penetration depth of
milling (depending on the milling tool) with operating lever (7)
• Move the operating lever (8) carefully to the right direction to the limiter
• Repeat this process until the requested cutting depth has been reached
• Move the operating lever (7) backwards to release the milling tool out of the workpiece
• After the working process switch of the machine (see operation planer and thicknesser)
• Before further activities wait until blade shaft is at a standstill!
17.1
After working process
After the working process the planer and thicknesser must be turned off:
•
Switch off the machine and disconnect the machine from the power supply.
Dismount the milling tool.
•
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION MORTISING UNIT (OPTIONAL)
Step 1:
Step 2:
Step 3:
N O TE
WAR N I N G
HOB305PROSMW2_230V | HOB305PROSMW2_400V
45
Publicité
