Publicité
Les langues disponibles
Les langues disponibles
16.7.2
Thicknessing of workpieces
•
In the case of resin residues on the wood, it may be advisable to apply a thin
layer of a special lubricant to the machine table in order to ensure that the
workpiece slides evenly through the thickness planer.
•
If the workpiece is no longer moved by the automatic feed, pull out the
workpiece manually.
•
After operation switch off the machine and set the lever for thicknesser feeder
to position "OFF".
•
Before further activities wait until blade shaft is at a standstill!
16.8
After working process
After the working process the planer and thicknesser must be turned off:
•
Switch off the machine and disconnect the machine from the power supply.
•
After operation set the lever for thicknesser feeder to position "OFF".
Adjust the planer knife cover so that the planer shaft is completely covered
•
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• Unlock the locking lever height adjustment
thicknesser (1) and set the required height of the
thicknessing table with the handwheel (2).
• The height will be shown on the scale (3).
• Set the thicknessing table height to the workpiece
height minus the requested cutting depth.
• Maximum cutting depth refer to the technical data!
NOTE:
At the beginning of the thicknessing process,
the workpieces may still have very different thicknesses
- this must be taken into account in the set cutting
depth in order not to overload the machine.
• Fix the thicknessing table height with the locking
lever height adjustment.
• Switch on the machine.
• Put the lever for thicknesser feeder (4) to the upper
position to start the feed.
• Insert workpiece so that the surface to be machined
facing upwards and push forward
• The workpiece is pulled through of the automatic
feed
• As soon as the half of the workpiece has been
processed change to the opposite operator side of
the machine and take on the finished workpiece.
• After operation switch off the machine.
• Before further activities wait until blade shaft is at a
standstill!
N O TE
N O TE
HOB305PROSMW2_230V | HOB305PROSMW2_400V
OPERATION
44
Publicité
