Publicité
Les langues disponibles
Les langues disponibles
16.7
Thicknessing
It is necessary to modify/adjust the machine before using as a thicknesser.
•
Long, protruding workpieces must be sufficiently supported! Use suitable aids such as roller
blocks etc. for this purpose. If you do not follow these instructions, there is a danger of the
workpiece being raised up quickly and/or the machine being tilted!
•
Use the thicknessing function only to reduce the thickness of a workpiece with an already
surface planed facing!
•
For workpieces with a difference in thickness, the chip removal must be measured at the
maximum thickness and the workpiece machined with this side first.
•
Make sure that the workpiece to be machined is free of foreign objects and/or knots in
order to avoid dangerous fractures.
•
Only plane workpieces that rest firmly on the machine and can be guided safely!
•
If several workpieces are to be processed in series, all pieces of the same thickness should
be run through in succession without changing the setting.
•
Perform the machining process from the beginning until the desired thickness is achieved.
16.7.1
Converting from planer to thicknessing
For readjusting to planer mode please lower the thicknesser table to lowest position
to avoid any damages.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O TE
• Disassemble the planer fence (1) and slide the planer
knife cover all the way to the back.
• Disassemble the hose of the dust collector plug.
• Unlock the fixation handles planer tables (2) of the
planer tables. Therefore pull out and turn the lever
• Unfold the planer tables (3) completely and ensure
that the locks (4) engages
• Turn down the dust collector hood (5).
• Mount hose to the dust collector plug (6).
Proceed in reverse order to readjust to the planer
mode.
N O TE
HOB305PROSMW2_230V | HOB305PROSMW2_400V
OPERATION
43
Publicité
