HOLZMANN MASCHINEN HOB305PROSMW2 230V Mode D'emploi page 37

15.6 Electrical connection
Dangerous electrical voltage!
 The machine may only be connected to the power supply and the associated
checks carried out by a qualified electrician or under the instruction and
supervision of a qualified electrician!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• Slide the planer fence (1) with the fixture
onto the bracket
NOTE: First loosen screw (3) and remove end
plate (4) of the bracket. After mounting the
planer fence, fix the end plate again.
• Fix the planer fence in desired position with
clamping levers (5)
4. Assembly rear protective cover
• Fix the rear protective cover (1) to the
holding rail of the planer fence using
screws (2) as shown
5. Assembly arm planer knife cover
• Push the arm planer knife cover (1) onto the
bracket (2) on the exit planer table (3) and
fix it with the clamping lever arm planer
knife cover (4)
6. Assembly planer knife cover
• Insert planer knife cover (1) into the holder
(2) and fix it in desired position with the
fixing knop (3)
WARNING
HOB305PROSMW2_230V | HOB305PROSMW2_400V
ASSEMBLY
37