Publicité
Les langues disponibles
Les langues disponibles
18.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
•
Remove chips and dirt particles from the machine after each use with a proper tool.
•
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
18.2
Maintenance
The machine is low maintenance and only a few parts require mainencance. Malfunctions or
defects that are likely to impair your safety must be rectified immediately!
•
Check that the safety devices are in good condition before each operation.
•
Check the connections at least once a week for a tight fit.
•
Check the correct and readable status of the Machine's warning and safety labels on a
regular basis.
18.2.1
Maintenanceplan
Wear of machine depends strongly on operation condition. The following intervals are valid when
using the machine within the operation limits
Interval
Componente
Anti-kick-back
Before every
device
usage
Machine
V-Belt
monthly
Feed/Pull-out roller
Height adjustment
Chain-drive (feed)
Half yearly
Friction wheel
(feed)
18.3
Checking/adjusting/replacing the V-Belt
The belt tension is set correctly for new machines ex factory. By stretching the belts over the
running time, retensioning of the belt is necessary.
To check/adjust or replace the belt, remove the belt/chain cover (1). Loosen the screws and remove
the cover.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O TE
Activity
At least once per work-shift by inspection to verify that
they are in good working condition, eg have no impact
damages to the surface and that the anti-kick back device
fall back freely due to its own weight after lifting.
Cleaning (from dust and chips)
Check retighten or replace if necessary.
Check and clean thoroughly
Control, lubrication
Check for damage/wear, lubricate, replace if necessary
Check for damage/wear and replace if necessary.
HOB305PROSMW2_230V | HOB305PROSMW2_400V
46
Publicité
