Ryobi RLM15E36H Traduction Des Instructions Originales page 6

Do not expose to rain or damp condition.
Beware of sharp blades. Blades
continue to rotate after the motor is
switched off – Remove plug from
mains before maintenance or if cord is
damaged.
Keep all bystanders, especially children
and pets, at least 15m away from the
operating area.
the cutting blades.
Press the Start button and then the
On-off button (A, B, C or D) to start the
product. Release the Start button and
keep pressing the On-off button to run
the product. Release the On-off button
to stop the product.
Go
Stop
Class II tool, double insulation
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or retailer
for recycling advice.
Conforms to all regulatory standards in
the country in the EU where the product
is purchased.
EurAsian Conformity Mark
The guaranteed sound power level is
shown on this label by 94 dB.
The guaranteed sound power level is
shown on this label by 95 dB.
The following signal words and meanings are intended to
explain the levels of risk associated with this product:
DANGER
Indicates an imminently hazardous situation, which, if not
avoided, will result in death or serious injury.
4 | English
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.
CAUTION
(Without Safety Alert Symbol) Indicates a situation that
may result in property damage.
SYMBOLS IN THIS MANUAL
Connect to power outlet.
Disconnect from power outlet.
Parts or accessories sold separately
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Keep hands away from blades
Note
Warning
Stop the product.
GENERAL MOWING TIPS
When cutting long grass, reduce walking speed to allow
for more effective cutting and a proper discharge of the
clippings.
Do not cut wet grass; it will stick to the underside of
the deck and prevent proper collection or discharge of
grass clippings.
New or thick grass may require a higher cutting height.
If you wish to collect the grass cuttings for disposal,
remove the mulching plug and fit the grass box making
sure the top flap is properly closed. Empty the grass
box regularly, otherwise the discharge chute will
become blocked with grass cuttings.
If you are making a light cut and wish for the grass
cuttings to remain on the lawn, fit the mulching plug and
close the top flap to cover the discharge opening. It is
not necessary to fit the grass box in this case.
The mower is designed to operate and cut most
effectively when moving forwards.