Beta Motorcycles EVO 4T EUROPA Mode D'emploi page 104

3
SUSPENSION ADJUSTMENT ACCORDING TO THE
MOTORCYCLIST'S WEIGHT
The following table shows the approximate calibration of the suspension adjustment
according to the motorcyclist's weight.
p < 70 Kg
Adjustment
Fork Shock absorber
Standard
ATTENTION! Shock absorber pre-load max permitted = +6 turns.
1
GB
70 Kg < p < 80 Kg
Fork
+ 5 turns
Standard
preload
2
10 m
Adjustment
Shock absorber
+ 1,5 turns
preload
HEADLIGHT ADJUSTMENT
•The beam is adjusted by changing the
inclination of the optical unit by turning
the screw 1 and the nut 2.
•Place the vehicle on level ground (but
not on the stand) 10 metres from a verti-
cal wall.
•Measure the height of the headlight cen-
tre above the ground and then draw a
cross on the wall at 9/10 of the height
of the headlight centre.
•Sit on the motor bike with only the high
beam headlight on and check that the
headlight beam on the wall is slightly
lower than the cross drawn previously.
Where this is not the case, proceed to
adjustment.
•Periodically check the direction of the
beam. The beam can only be adjusted
vertically.
When adjustment is complete, make sure
that nut 2 is fully tightened towards the
instrument support.
32
80 Kg < p
Adjustment
Fork Shock absorber
+ 10 turns + 3 turns
preload preload