Beta Motorcycles EVO 4T EUROPA Mode D'emploi page 101

3
ADJUSTMENT OF GAS
2
1
CLEARANCE
3
The throttle control cable should always
have a 3-5 mm play. In addition, the idle
speed should not change when the han-
dlebars are fully rotated to the left or right.
To adjust the clearance proceed as follows:
- Loosen ring 1.
- Rotate register 2 with respect to sheath 3.
- Tighten ring 1.
ACCELERATOR
ADJUSTING THE IDLE SPEED
A
In order to perform this operation correctly,
we advise you to do it when the engine
is hot, connecting an electric revolution
counter to the spark plug wire. Then use
a screwdriver on register screw A to
calibrate the minimum with 1.100÷1.200
rpm.
HANDLEBAR ADJUSTMENT
The handlebar can be adjusted by rotating
it back and forth.
- To adjust the handlebar loosen screws 1.
- Position the handlebar according to
requirements.
- Tighten to the torque indicated.
1
20Nm
GB
29