Beta Motorcycles EVO 4T EUROPA Mode D'emploi page 100

3
2
0,9 mm
GB
KEY TO SYMBOLS
Tightening torque
Threadlocker Medium
Grease
CLUTCH
1
The position of the lever is controlled
through the use of register 1.
Once the position of the lever has been
changed, register 2 must be changed to
restore the initial correct clearance.
The idle stroke of push rod must not be less
than 0.9 mm
ATTENTION: reduced clearance
leads to premature wear of the discs
and overheating of the entire clutch
group.
28