Safety Thermostat; Aftersales Service - FriFri Frita+ 6 Manuel D'installation Et Mode D'emploi

11. Safety thermostat

Your fryer is fitted with a safety thermostat according to the latest regulations.
If the thermostat does not work properly or the oil leve lt'is not sufficient, automatically the safety thermostat
intervenes to disconnect the heating elements.
If the safety thermostat stops the machine, call the nearest repair centre.
12. After-sales service
Should you have any problems with your fryer, contact your nearest service centre. Before contacting it check the
following points:
1. Has the mains fuse blown?
2. Is the mains plug plugged in?
3. Is the mains cable in good condition?
4. Is the fuse of the control defective?
5. What about the safety thermostat? It can cut off for the following reasons:
- Not enough oil or fat in the container.
- The heating elements were switched on for too long during the fat melting process.
Important:
When calling your service centre, give model and serial number of your appliance. These ones are indicated on
the data plate located behind the control box.
It is worthwile filling in the type and number of your fryer below:
Type ______________________________________________
Apparatus-No. ______________________________________________
Tension ______________________________________________
Date of installation ______________________________________________
After-sales service ______________________________________________
Telephone number ______________________________________________
Subject to technical modifications.
page: 15 / 20