Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. Warnings
The fryer should never be allowed to work empty. Should this happen by mistake, the safety thermostat will cut off the
fryer. An overfilled basket or filled with products that are too wet (eg. ice crystals on frozen food) will make the oil
froth and this will reduce the quality of the fried food!
If the oil catches fire, use an extinguisher blanket or an extinguisher system. Put the main switch on 0 and pull out
the plug! NEVER POUR WATER ONTO BURNING OIL!
To extinguish burning oil, it is necessary to have a fire extinguisher or a fixed extinguishing system at hand.
Never move the fryer when it is hot!
Before taking out the tank to change the oil, wait for the oil cools down to a max. of 60˚C.
Old and spoiled oil will more easily foam over and catch fire.
Danger of fire if oil level does reach the lower mark!
9. Daily maintenance
Before carrying out maintenance tasks, switch off the fryer and unplug it. It is advisable to wear gloves to avoid being
burnt by hot oil, metal parts and handles. The oil or fat should be filtered daily as follows:
1. Oil temperature at max. 60˚C.
2. Remove basket.
3. Put the control box with the heating elements in drain position (raise the control box to the catch).
4. Let the oil drain and then remove the control box.
5. Drain the oil on the Frita 6&8 with the drain valve.
6. Remove the container. Warning: the handles of the container will be hot! Decant the oil or fat at a temperature of
max. 60˚C.
7. Pour the oil or fat back into its container and, if necessary, fill up to the MAX level.
Important:
Used oil should be treated according to the local regulations and should on no account be poured down the drain.
10. Cleaning / Maintenance
Before carrying out maintenance tasks, switch off the fryer and unplug it. It is advisable to wear gloves to avoid being
burnt by hot oil, metal parts and handles. Regular cleaning will make your fryer lasts longer and improves the quality
of the fried food. The fryer should therefore be cleaned daily as follows:
1. Remove basket and put the control box with the heating elements in.
2. Drain the oil on the Frita 6 & 8 with the drain valve.
3. Take out the control box with the heating elements, remove the container and empty it.
4. Clean the heating elements with warm water and a mild detergent.
5. The case is made of stainless steel and may also be cleaned with the same product.
Important:
Do not squirt control box with water or even drop it into water.
Clean the heating elements with a normal soft brush, do not use a metal brush to clean the heating elements.
Take care to avoid damaging the thermostat probes. Avoid banging the heating elements.
Cleaning the heating element by incandescence (running empty) is forbidden and would invalidate the
guarantee. The fryer should not be washed with a water jet or high pressure jet.
page: 14 / 20
Publicité
Table des Matières
