Protecting Against Rays And Burns; Installing The Welding Shield - Parkside PISG 80 A1 Traduction Des Instructions D'origine

- Open windows or vent to ensure
air supply.
- Wear safety goggles and a
mask.
Wear gauntlet gloves made
from suitable material (leather)
on both hands. These must be in
good condition.
Wear suitable aprons to protect
the clothing from sparks and
burns. When required based on
the working method, e.g. welding
overhead, wear a protective suit
and, if necessary, a head guard.
Protecting against
rays and burns
Mark the work area with a
sign „Danger! Do not look into
flames!" to indicate the risk to
the eyes. If possible, shield the
work areas to protect persons
nearby. Keep unauthorised per-
sons away from the welding area.
Walls in the direct vicinity of fixed
work areas should be neither
light coloured nor glossy.
Protect windows against rays
passing through or reflecting at
a minimum to head height, e.g.
with suitable paint.
Safety instructions / Installing the welding shield / Start-up

Installing the welding shield

Install the handle
8
as shown in Fig. C.
Install the protective glass
shield as shown in Fig. C.
7
Then fold the three sides of the welding shield.
The two sides each connect to the top with two
press studs.
Start-up
Note: The welding tool is suitable for welding with
electrodes.
Use electrode retaining clips without protruding
retaining screws meeting today's safety stand-
ards.
Be sure the ON / OFF switch
tion "O" ("OFF") or the main supply cable is
not plugged into the mains socket.
Connect the welding cables according to po-
larity and electrode manufacturer instructions.
The welding circuit should not be intentionally
be brought into direct or indirect contact with
the safety cable unless on the welding part.
When intentionally welding to the workpiece
via safety cable, the connection must be as
short as possible.
The cross-section of the safety cable must be
at least the same cross-section as the welding
current return cable.
Both cables must be connected to the workpiece
in the same location. Use the earthing lug on
the tool or a nearby earthing lug.
All safety measures must be taken to prevent stray
current. Verify the mains voltage of the input
voltage matches that of the tool (see type plate).
Put on suitable protective clothing according to
provisions and prepare the work area.
Connect the earth terminal to the workpiece.
Secure the electrode in the electrode holder
Switch on the device by setting the ON / OFF
switch to the "I" ("ON") position.
9
Set the welding current with the control knob
according to the electrode used.
on the welding shield
7
on the welding
11
is set to posi-
9
5
GB/IE
.
3
29