Reset The Transmitter To The Factory Setting - Becker Centronic EasyControl EC715 Notice De Montage Et D'utilisation

Activating/deactivating the fly screen protection
function
Put the transmitter into master mode.
Select the receiver by pressing the
firms.
All the following settings will then only be executed for this device.
5s

Reset the transmitter to the factory setting

Attention
If the transmitter is reset to factory settings, master mode
will no longer give you access to the receiver or receivers in
which the transmitter has been programmed. Please only
make this setting when the battery is new. After the device is
reset, it requires roughly 10 seconds to restart. The device
does not work during this time.
Take out the battery.
Then press and hold the master button
correct way round.
▻ LEDs L1 and L2 flash 3 times
► The factory settings of the transmitter have now been restored.
button until the desired receiver con-
Open the shading solution to the upper limit posi-
tion.
Then press the teaching button and also the STOP
and UP buttons for approximately 5 seconds.
▻ The receiver confirms.
► The fly screen protection function is now ac-
tivated/deactivated.
while you reinsert the battery the
67 - en