Becker Centronic EasyControl EC715 Notice De Montage Et D'utilisation page 64

Setting the desired intermediate position
or
Setting the desired tilt position when operating blinds
or
Travelling to the desired intermediate position/tilt
position
2x
or
2x
64 - en
Open/close the shading solution to the desired in-
termediate position.
Press the STOP button and, within 3 seconds, also
press the desired travel button and hold the two
buttons down.
▻ The receiver confirms.
► The intermediate position is now saved.
Move the blind from the upper limit position to the
position at which you wish to attach the tilt.
Press the STOP button repeatedly until the de-
sired tilt position is reached.
Press the STOP button and, within 3 seconds, also
press the desired travel button and hold the two
buttons down.
▻ The receiver confirms.
► The tilt position is now saved.
Press the travel button for the desired intermedi-
ate position/tilt position twice within one second.
► The shading solution runs to the intermedi-
ate position/tilt position assigned to the
travel button.