Programming Additional Transmitters - Becker Centronic EasyControl EC715 Notice De Montage Et D'utilisation

Programming additional transmitters

In addition to the master transmitter, up to 15 further trans-
mitters (of which a maximum of three can be sensors) can be
programmed in the radio receiver.
3s
3s
3s
Press the programmed master transmitter's pro-
gramming button for 3 seconds.
▻ The receiver confirms.
Now press the programming button of a new
transmitter which has not yet been programmed in
the radio receiver for 3 seconds. Doing so activ-
ates the programming mode of the radio receiver
for a new transmitter for 3 minutes.
▻ The receiver confirms.
Now re-press the programming button of the new
transmitter you wish to program for 3 seconds.
▻ The receiver confirms.
► The new transmitter has now been pro-
grammed.
47 - en