Programming The First Transmitter - Becker Centronic EasyControl EC715 Notice De Montage Et D'utilisation

Activating master mode
Press the master button
continue as long as you remain in master mode.
By pressing the master button
or the programmed receivers are selected in sequence.
The selected receiver confirms.
You can now make the various settings that are only available in master mode.
When all the desired settings have been made at this receiver, you can press
the master button
Leaving master mode
There are two ways to leave master mode:
1. Turn the function switch to "0".
2. Master mode is automatically closed once 2 minutes have gone by
without a button being pushed.

Programming the first transmitter

The function switch must always be set appropriately for the
receiver.
Putting the receiver into programming mode
Follow the Assembly and Operating Instructions for the re-
ceiver.
• Switch off the power supply to the receiver for 5 seconds, then switch it
back on.
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in programming mode for 3 minutes.
52 - en
until the status LED (L2) flashes. This flashing will
again, the programmed receiver is selected,
again to select the next receiver for programming.