Upper Stop To Lower Point; Upper Point To Lower Stop - Becker Centronic EasyControl EC715 Notice De Montage Et D'utilisation

Upper stop to lower point

Put the transmitter into master mode.
Select the tubular drive by pressing the
firms.
All the following settings will then only be executed for this device.

Upper point to lower stop

Put the transmitter into master mode.
Select the tubular drive by pressing the
firms.
All the following settings will then only be executed for this device.
button until the tubular drive con-
Open to the permanent upper stop.
▻ The tubular drive switches off automat-
ically.
Then close to the desired lower limit position.
Press the programming button and, within 1
second, also press the DOWN button and hold the
two buttons down.
▻ The receiver confirms.
► The limit positions are now set.
button until the tubular drive con-
Open to the desired upper limit position.
Press the programming button and, within 1
second, also press the UP button and hold the two
buttons down.
▻ The receiver confirms.
Then close to the permanent lower stop.
▻ The tubular drive switches off automat-
ically.
► The limit positions are now set.
59 - en