Programming More Transmitters - Becker Centronic EasyControl EC715 Notice De Montage Et D'utilisation

Programming transmitter
Please make sure that only one receiver is in programming
mode at any time. It is not possible to program/clear multiple
receivers at the same time.
3s

Programming more transmitters

The receiver mode must always be set appropriately for the
receiver. Roller shutter is the factory setting.
Programming more B-Tronic transmitters in the B-
Tronic receiver
Put the receiver into programming mode.
Please make sure that only one receiver is in programming
mode at any time. It is not possible to program/clear multiple
receivers at the same time.
Press the programming button of the transmitter
for 3 seconds whilst in programming mode.
▻ The receiver confirms.
► Programming is now complete.
53 - en