Becker Centronic EasyControl EC715 Notice De Montage Et D'utilisation page 61

Deleting both limit positions
Put the transmitter into master mode.
Select the tubular drive by pressing the
firms.
All the following settings will then only be executed for this device.
5s
button until the tubular drive con-
Open/close the shading solution to a point
between the limit positions.
Press the programming button and, within 1
second, press the STOP button at the same time
and hold the two buttons down for 5 seconds.
▻ The receiver confirms.
► The limit positions are now deleted.
61 - en