Publicité
Assignment of the receiver channels to the control levers when the transmitter is delivered (Mode 2)
Channel
Function
Ch 1 (Channel 1):
Ailerons (roll)
Ch 2 (Channel 2):
Elevators (nick)
Ch 3 (Channel 3):
Throttle (throttle/pitch) Left
Ch 4 (Channel 4):
Rudder (tail)
Ch 5 (Channel 5):
Not available
Ch 6 (Channel 6):
Not available
Bat:
Receiver battery
How to assemble the receiver and the receiver module
The installation of the receiver depends on the model. For this reason, you should always follow the recommenda-
tions of the model manufacturer regarding receiver installation. Regardless of the model, you should always try to
install the receiver so that it is protected from dust, dirt, moisture and vibration in the best possible way. Two-sided
adhesive foam (servo tape) or even rubber rings that hold the foam-wrapped receiver securely in place are suitable
for fastening.
The receiver module has to be mounted such that its antenna is in a position perpendicular to
the antenna of the receiver.
Installing the servos
The installation of a servo is always dependent on the particular model used. For specific information, refer to the
design documents of the model. However, generally you should try to fasten the servos with screws in such a way that
vibrations are minimised. For this purpose, servos are typically supplied with rubber bushings with metal sleeves.
Checking the control functions
Connect the servos and/or speed controllers and the power supply to the receiver.
Switch on the transmitter and then the receiver. If you have connected everything correctly, all the servos should
respond correctly.
If one or more functions should not respond correctly, then you can correct the relevant adjustments.
34
All manuals and user guides at all-guides.com
Control lever
Right
Right
Left
Direction
right/left
forward/backward
forward/backward
right/left
Publicité
