Scheppach HS 720 Traduction Des Instructions D'origine page 29

15. Sawing operation
1. After the machine has been switched on, wait until the saw blade has reached full speed.
2. Place the wood in the swivel frame.
3. Hold the handle of the swivel frame with both hands and guide it evenly towards the saw blade.
4. Only apply enough pressure on the swivel frame when sawing so that the speed of the saw blade does not drop.
5. Remove the sawn wood from the swivel frame after it has returned to its original position and the saw blade is covered.
Now place the next piece of wood on.
m Attention!
• Do not leave the machine unattended during operation
• Switch the machine off when stopping work and remove the mains plug or spark plug connector.
End of work
• Switch off the drive motor with the On/Off switch.
• Wait until the saw blade has come to a complete stop.
• Re-fit the mains plug / spark plug connector.
• Observe general maintenance information.
• Bring the swivel frame to the transport position and secure it with the swivel frame lock.
16. Maintenance and service
m Only carry out maintenance, modification, adjustment and cleaning work when the engine is switched off
and the mains or spark plug connector is disconnected.
• Keep the instructions with the machine.
• Keep the machine clean.
• Wear safety goggles when cleaning.
Before starting the maintenance or checks, clean the work area and have suitable tools at hand and in good condition.
The time intervals relate to normal operating conditions. If the machine is subjected to heavier loads, these times must
be reduced accordingly.
Clean the machine cladding, panels and control levers with a soft, dry cloth or a cloth that has been slightly moistened with
neutral cleaning agent. Do not use any solvents such as alcohol or petrol as these may damage the surfaces.
Keep oils and lubricants out of reach of unauthorised persons. Read through the instructions on the containers carefully
and follow them closely. Avoid direct contact with the skin and wash off thoroughly after use.
m Check all safety devices after all maintenance or cleaning work.
Servicing
Switch the engine off and let it cool down. Re-fit the mains plug / spark plug connector.
Check the general condition of the machine. Check for loose screws, misalignment or jamming of moving parts, part
breakages and other conditions that could impair safe operation.
Remove all foreign objects and other materials that have collected on the saw blade and on the unit. Clean the machine
after every use. Then use a high-quality, low-viscosity machine oil to lubricate all moving parts.
m Never use a high-pressure cleaner to clean your machine. Water can penetrate sealed areas of the machine
and the transmission housing and cause damage to spindles, gear wheels, bearings or the engine. The use of
high-pressure cleaners shortens the service life and reduces the ease of maintenance.
Experienced craftsmen can carry out small repairs on the machine themselves.
• Check the saw blade at regular intervals. Use only saw blades that are well sharpened, free of cracks and not deformed.
Only use tools that comply with the European standard DIN EN 847-1.
• Replace worn swivel frame bearings immediately.
• Check all safety devices after all maintenance or cleaning work.
• Check that no tools or miscellaneous parts are on or in the machine before putting it back into operation.
• Remove any sawdust accumulations that may arise at the discharge.
Service information
With this product, it is necessary to note that the following parts are subject to natural or usage-related wear, or that the
following parts are required as consumables.
GB | 29
www.scheppach.com