Sew Eurodrive MOVIGEAR DBC B Correctif page 7

3 Installation électrique
3.1 Consignes d'installation
3.1.1 UL-compliant installation
REMARQUE
Le chapitre suivant est toujours en anglais, indépendamment de la langue de la pré-
sente documentation et ce en raison des prescriptions UL.
Power terminals
Observe the following notes for UL-compliant installation:
•
•
Short circuit current rating
Suitable for use on a circuit capable of delivering not more than 200,000 rms symme-
trical amperes when protected by 600 V non-semiconductor fuses or 500 V minimum
inverse time circuit breakers.
•
Suitable for motor group installation on a circuit capable of delivering not more than
5,000 rms symmetrical amperes when protected by maximum 40 A, 600 V non-semi-
conductor fuses or 500 V minimum 40 A maximum inverse time circuit breaker.
•
Branch circuit protection
Integral solid state short circuit protection does not provide branch circuit protection.
Branch circuit protection must be provided in accordance with the National Electrical
Code and any additional local codes.
The table below list the permitted maximum branch circuit protection:
Series
MOVIGEAR
Use 75 °C copper wire only.
Tighten power terminals to 1.2 – 1.4 Nm (10.6 – 12.4 lb.in).
MOVIGEAR ® , the max. voltage is limited to 500 V.
MOVIGEAR ® , the max. voltage is limited to 500 V.
®
Non-semiconductor
fuses
40 A / 600 V
Correctif – MOVIGEAR
Installation électrique
Consignes d'installation
Inverse time circuit
breakers
500 V minimum /
40 A maximum
®
DBC B, DAC B, DSC B, SNI B,
3
7