Bras AB 1/10 Carnet D'instructions page 14

EN GLIS H
A B - B S
outside the bowl (see figure 9).
4
Place bowl on the unit, with gasket around the cooling
dome, then push it down all the way.
Wet cooling dome and gasket for ease of insertion.
5
BS lines: raessemble pump assembly; place it into bowl
location and turn it counterclockwise until it stops into position.
6
AB - BS2M line: replace stirrer onto its shaft and drop it into
place freely.
5. 3. 6 FAUCET ASSEMBLY
5. 3. 6. 1 BS LINES WITH PINCH TUBE
FAUCET
1
Fit the faucet cover and the faucet body by reversing
disassembly operations (see figure 5).
2
Push (1) the dispensing handle and insert (2) the pinch tube
into its vertical seat in the bowl bottom (see figure 10).
3
Lightly pull (3) the pinch tube end downwards till it is well
All manuals and user guides at all-guides.com
figure 9
figure 10
arranged. (see figure 11).
5. 3. 6. 4 BS LINES WITH GRAVITY
FAUCET
4
Fit the faucet body by reversing disassembly operations
(see figure 7).
5
Install the faucet handle (1-2) and the piston with its gasket
(3) (see figure 12).
5. 3. 6. 6 AB LINE
6
Fit the faucet cover and the faucet body by reversing
disassembly operations (vedere figure 5).
7
Insert the pinch tube into its horizontal seat in the bowl
bottom (see figure 13).
8
Insert the pinch tube end into the faucet body vertical seat
14
figure 11
figure 12
figure 13