Toro Recycler 22 Manuel De L'utilisateur page 11

Bagging the Clippings
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
Note: Ensure the bag is seated in the correct position.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
bagging the clippings. If the bag-on-demand lever is in
the recycling position, move it to the bagging position
(refer to Operating the Bag-on-Demand Lever).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Raise and hold up the rear deflector (Figure 19).
1. Notches
2. Rear deflector
2. Install the grass bag, ensuring that the pins on the
bag rest in the notches on the handle (Figure 19).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps above.
11
Figure 19
3. Grass bag pin (2)