Tanita innerScan RD-953 Manuel D'utilisation page 6

en
Preparations before Use
Inserting the Batteries
Note:
・Be sure that the batteries are inserted in the correct orientation. If the batteries are
inserted incorrectly, fluid may leak from the batteries and damage the floor.
・If you do not intend to use this unit for a long period of time, remove the batteries
before storage.
・The included batteries from factory may have decreased energy levels over time.
Set your location code
Different locations across the world have different gravitational
pulls. These differences affect the accuracy of the weight
measurement. You can obtain the most accurate weight readings by
selecting the correct gravity setting on the scale according to your
geographical location.
1.When the power is off, press and hold the button.
2.Refer to the map enclosed, and press the buttons to select
your location code.
3.Press the button to enter and save the setting.
Changing the Weighing Unit
Note: Only for use with models that have the unit switching button.
The weighing unit can be changed using the switch on the back of the monitor.
Press the button when the display is blank. When "0.00kg" (or "0.0lb", "0.0stlb") appears on the display, press the Unit Switching
button underside of the monitor to switch the weighing unit.
Note: If weighing unit is set to pounds or stone-pounds, the height programming mode is automatically set to feet and inches.
Similarly, if kilograms is selected, height is automatically set to centimeters.
6
Up Button
SET Button
Down Button
Off Button