Publicité
Les langues disponibles
Les langues disponibles
RS232/LAN Command Table
Command
TOF
RST
STV
GTZ
CTZ
STL
SMA
get_mac_address
GETMACADDRESS
GETGPIO
SETGPIOLOW
SETGPIOHIGH
ADMIN PANEL COMMANDS
Description
Turn off panel
Restart
Sets panel Volume,
parameter value will ve
set for volume level
Get Time Zone
Change Time Zone.
Set panel Language
Set mac address
Note: This command
is not available for
MB230 platform.
Instead, set_mac_
address command can
be used.
Note2: This command
only changes mac
address of wired
interface.
Note3: Reboot needed.
Get mac address
Gets mac address
of selected network
interface
Gets the GPIO's state
Sets the GPIO's state
to low
Gets the GPIO's state
to high
English - 28 -
Parameter
no parameter
no parameter
or
int (wait seconds until
Restart)
integer (volume level)
no parameter
integer (gmt value )
string-int (please look
at abbreviations of
languages)
string-int ( ex: eth0-
00:09:df:86:34:25)
none
none
pin number(visit the GPIO
List)
pin number(visit the GPIO
List)
pin number(visit the GPIO
List)
Return
#Display will be sent to Active
Standby state.
or
#Display is in Active Standby
state already!
#Display will be restarted
#Volume set level= ...
#Timezone is ...
#Timezone setup
SUCCEEDED
#Language changed to ...
or
#Wrong language selection.
#SetMacAdress Successful
#*FAILURE - Invalid mac
address!
#*FAILURE - Could not write
MAC address!
#*Hwaddr: mac_address -
Succesfull
#*Hwaddr: <mac_address> -
Succesfull
or
#*Mac address could not be
obtained
#*GPIO level is ...
#*... is set to HIGH
#*... is set to LOW
Publicité
