Kimex 160-4075T Manuel D'utilisation page 108

SETMODE_WIFIBT
SETMODE_USB
SETSIGNAGEID
GETSIGNAGEID
SHOWSIGNAGEID
Command
get_IP_address
SAVEWIFIPROFILE
Wifi
GETNETWORKTYPE
SETSUBNETMASK
GETSUBNETMASK
Set the wifi&bt switch
value
Set the Front&Internal
USB status value
Set Signage ID
Get Signage ID
display signage ID on
screen
NETWORK COMMANDS
Description
Get IP address of eth0
network interface.
Usage: get_IP_address
Save access point to
wifi_profile.
checks if given SSID
wifi is found or not and
returns Pass or Fail.
get network type (eg.
GETNETWORKTYPE)
set subnet mask (subnet
mask value should be of
format nnn.nnn.nnn.nnn)
(eg. SETSUBNETMASK
nnn.nnn.nnn.nnn)
get subnet mask (eg.
GETSUBNETMASK)
English - 40 -
string wifibt string usb
string (Display,OPS,Auto)
string usb string wifibt
string (Display,OPS,Auto)
integer n
no parameter
no parameter
Parameter
no parameter
str-int ssid, bssid key
str-int ssid
no parameter
string "nnn.nnn.nnn.nnn"
no parameter
#*Wifi & BT Switch Mode
is set to *****
or
#*Wifi & BT Switch Mode
is not set (invalid input)
#*USB Mode is set to *****
or
#*USB Mode is not set
(invalid input)
#*Set Signage ID
Success.
or
#*Wrong parameter.
Parameters must be
integer
#*The signage ID is ...
or
#*The signage ID is 0
#*Do not forget to enter
signage ID! (If
return value is 0)
#* Signage ID is ...
or
#* Signage ID is 0
#*Do not forget to enter
signage ID! (If
return value is 0)
Return
#*IPaddr: ...
Profile saved.
or
Number of profiles
exceeds the maximum
number to be stored.
#*Pass
or
#*FAIL
#*the network type is
<network-type>
#*set subnet mask: nnn.
nnn.nnn.nnn
or
#*setting subnet mask is
failed
#*the subnet mask is nnn.
nnn.nnn.nnn