GE 22 Série Manuel D'utilisation Et D'installation page 22

INSTALLING THE REFRIGERATOR
PUT THE REFRIGERATOR IN PLACE
4
Move the refrigerator to its final location.
LEVEL THE REFRIGERATOR
5
The refrigerator can be leveled by adjusting
the rollers located near the bottom hinges.
Rollers have three purposes:
• Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about
5/8" [16 mm] from the floor.)
• Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
• Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers:
• Turn the roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use a
3/8" hex socket or
wrench, or an
adjustable wrench.
Installation Instructions
Rollers
Raise
Roller adjusting screw
(CONT.)
LEVEL THE DOORS
6
Adjust the refrigerator door to make the doors
even at the top.
To align:
A Using a 7/16" wrench, turn the door adjusting
screw to the right to raise the door, to the left
to lower it.
NOTE:
A nylon plug, imbedded in the threads
of the pin, prevents the pin from turning unless
a wrench is used.
After one or two turns of the wrench, open
B
and close the refrigerator door and check
the alignment at the top of the doors.
22
Doors should be even at top
Raise
7/16" wrench