Beem 05015 Mode D'emploi page 38

Les langues disponibles

Descaling

Limescale deposits have an adverse effect not only on the quality of the coffee and the water,

but they also cause power losses and shorten the lifespan of the device. The thicker a limescale

layer is, the more difﬁ cult it is to remove.

We therefore recommend regularly removing limescale deposits with a descaling agent in

accordance with the water quality in your area and how often the device is used (approx. every

2 – 6 weeks).

The ﬁ rst indications that descaling is required are a large amount of steam being produced and

slower brewing of the coffee.

For descaling we recommend the BEEM Premium Descaler Concentrate. The efﬁ cient, food-

safe and environmentally friendly BEEM Premium Descaler Concentrate is available from selected

specialist stockists, via our website www.beem.de or from our customer service department on

request.

Descaling with the BEEM Premium Descaler Concentrate

1. Fill the water tank (h) up to the MAX marking with a concentrate / water solution of no

more than 1:20 (one part concentrate to 20 parts water).

2. Switch on the device by touching the ﬁ eld

ﬂ ash. The device starts the heating process. As soon as all operating ﬁ elds are permanently

lit, the device is preheated.

3. Insert the portaﬁ lter (d) into the device (see the "Handling and Operation" chapter –

"Inserting the Portaﬁ lter into the Device").

4. Place a suitable vessel under the portaﬁ lter.

5. Start the brewing process by touching the ﬁ eld

and water runs through the portaﬁ lter into the cup.

6. Allow roughly a third of the solution to run through and then touch the ﬁ eld

7. Allow the descaling solution to take effect for a little while.

8. After around 30 minutes, touch the ﬁ eld

through.

9. Rinse the water tank thoroughly and to rinse the device allow two tankfuls of clear water to

run through it.

10. Rinse all detachable parts thoroughly with clear water. The device is now descaled and

ready to be used again.

05015_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 38

(4). The other operating ﬁ elds light up and

(2). The device starts the brewing process,

again and allow the rest of the solution to run

again.

29.01.2021 15:11:12

Cm5403ea-gs