Clutch Torque Setting; Led Light; Installing The Shoulder Strap - Panasonic EY6803 Instructions D'utilisation

Forward/Reverse Lever
Forward
Be sure to set the switch in the center
to lock it after use.
Operate the Forward/Reverse lever
after the motor rotation is completely
stopped.
Hammering/Drilling Switching Lever
NOTE: Operate the mode change after
the motor rotation is completely
stopped.
Position of
Action mode
switching lever
Rotation with
hammering
Rotation only

Clutch Torque Setting

Adjust the torque to one of the 5 clutch
settings or " " position.
CAUTION:
Test the setting before actual operation.
Set the scale at this mark (
Variable Speed Control Trigger
To set the center of a hole, pull the
trigger slightly to start the drill rotation
slowly.
The more the speed control trigger is
pulled, the higher the speed becomes.
EY6803(UL).indb 7
Reverse
Lock
Operation
Concrete
Drilling,
Block Drilling
Screw
Fastening,
Metal Drilling
).
- 7 -

LED Light

CAUTION:
• The built-in LED light is designed
to illuminate the small work area
temporarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
Depress the trigger
switch, then LED light
turns on. When the
t r i g g e r s w i t c h i s
released, the light
turns off automatically.
The light illuminates with very low
current, and it does not adversely affect
the performance of the driver during
use or its battery capacity.
This product has the built-in LED light.
This product is classified into "Class 1
LED Product" to EN 6085-1
Class 1 LED Product
Caution : DO NOT STARE INTO BEAM.

Installing the Shoulder Strap

CAUTION:
• Install the shoulder strap firmly to
the main unit of the tool and check
the length of the strap before use.
• Check the condition of the strap
and do not use if it is cut or torn
etc.
There is a risk of injury or damage
if used while improperly installed.
• Please wear the shoulder strap se-
curely on the shoulder.
There is a risk of injury or damage
if it is accidentally dropped.
1. Pass the strap through the strap
holders. (1)
. Pass the strap through the buckles
and adjust the length. (2)
2006/04/11 16:51:46