Clutch Torque Setting; Speed Selection - Panasonic EY7460 Instructions D'utilisation

NOTE:
When the brake operates, a braking
sound may be heard. This is normal.
Switch and Forward/Reverse
Lever Operation
Forward
Switch lock
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the amount
of depression of the trigger for efficient
tightening of screws and drilling.
The brake operates and the chuck
stops immediately when the trigger is
released.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation.
Check the direction of rotation before use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
position (switch lock).
EY7460_EY7960_Book.indb 8

Clutch Torque Setting

Adjust the torque to one of the 18 clutch
settings or " " position (EY7460).
Adjust the torque to one of the 18 clutch
settings or " ", "
NOTE:
Always make sure to stop operation
of the tool and disengage it from the
work, when you select Hammering
mode from Drilling mode or when you
shift to Drilling mode from Hammering
Reverse
mode by rotating clutch handle.
CAUTION:
Set the clutch setting at this mark ( )
before actual operation.
If the clutch handle cannot be set at
"drilling" or "hammering" mode after
driving with clutch function, set the
clutch handle at position 1 and operate
the clutch for a second.

Speed Selection

Choose a low or high speed to suit the
use.
The more the variable speed control
trigger is pulled, the higher the speed
becomes.
- 8 -
" position (EY7960).
HIGH
LOW
2013-12-2 16:12:23