Viewing The Station Name Or Frequency In The Front Panel Display - Sony HT-CT350 Mode D'emploi

4
Press X/x repeatedly until "NAME IN"
appears in the front panel display.
5
Press .
6
Create a name by using
Press X/x to select a character, then press c
to move the cursor to the next position.
Letters, numbers, and other symbols can be
input for a radio station name.
If you enter a wrong character
Press C/c repeatedly until the character to
be changed flashes, then press X/x to select
the desired character.
To delete the character, press C/c
repeatedly until the character to be deleted
flashes, then press CLEAR while pressing
and holding SHIFT.
7
Press .
"COMPLETE" appears in the front panel
display, and the station name is stored.
8
Press MENU.
Tip
• You can check the frequency in the front panel display
by pressing DISPLAY repeatedly.
Viewing the station name
or frequency in the front
panel display
When the system is set to "TUNER FM" or
"TUNER AM," you can check the frequency
using the front panel display.
36
US
C c
/X/x/ .
Press DISPLAY.
Each time you press DISPLAY, the station name
and the frequency alternate in the front panel
display.
Tips
• The station name is displayed if you have entered a
name for a preset station.
• The frequency in the front panel display switches to
the station name after several seconds.
Changing the AM tuning
interval
The AM tuning interval can be set to either 10
kHz or 9 kHz.
1
Tune in to an AM broadcast.
2
Press ?/1.
The system enters standby mode.
3
While holding down INPUT SELECTOR,
press ?/1 of the subwoofer.
The interval changes to that shown in the
front panel display: "AM 9K STEP" or
"AM10K STEP."
If you want to return to the previous
interval, perform steps 1 to 3 again.
Note
• If you change the interval, all AM preset stations will
be erased.
DISPLAY