Sony HT-CT350 Mode D'emploi page 32

3
Press the input buttons to display the
input source in the front panel display.
Input source Playable component
TV TV, etc. connected to the TV
jack
BD Blu-ray Disc player, etc.
connected to the BD jack
DVD DVD player, etc. connected to
the DVD jack
SAT/CATV Satellite tuner or cable
television tuner, etc. connected
to the SAT/CATV jack
VIDEO DVD player, etc. connected to
the DIGITAL COAX IN
VIDEO jack
SA-CD/CD CD player, etc. connected to the
SA-CD/CD AUDIO IN jack
TUNER FM* The built-in FM radio
TUNER AM* The built-in AM radio
DMPORT Portable audio player, etc.
connected to the DMPORT jack
* Press TUNER repeatedly to switch between
TUNER FM and TUNER AM.
4
For video components, change the TV's
input to the HDMI input you chose in
step 3.
For details, refer to the operating
instructions of your TV.
5
Adjust the volume by pressing
MASTER VOL +/–.
Tips
• The sound may be output from the TV's speaker. In
this case, turn the volume of the TV's speaker down
to minimum.
• Even if you playback Dolby True HD, Dolby Digital
Plus or DTS HD with a connected component
compatible with these sound formats, the system
accepts the signal as Dolby Digital or DTS. When you
playback these high-quality sound formats, set the
connected component to output the sound in multi-
channel PCM, if possible.
32
US
Notes
• When you connect the video output jack of the
DIGITAL MEDIA PORT adapter to the video input
jack of the TV, set "CTRL HDMI" to "OFF" in the
AMP menu of the system (page 39). The images of a
component connected to the DIGITAL MEDIA
PORT adapter will not be played on the TV if "CTRL
HDMI" is set to "ON."
• To enjoy the sound of a component without
displaying the images when "CTRL HDMI" is set to
"ON," turn off the TV first and then reset the power of
the system.
If you turn on the system first and then turn off the
TV, all components connected to the TV will be
turned off because of the Control for HDMI function.
If you are using "BRAVIA" Sync
(One-Touch Play)
You do not need to perform steps 2 to 4 above.
When you turn on the connected components,
the system and the TV are also turned on, and the
input source changes automatically. You can
also adjust the system's volume using the TV's
remote.
For details on setting "BRAVIA" Sync, see
"Preparing for "BRAVIA" Sync" (page 38).
Tip
• The system is not turned on when you turn the TV on
if sound was being output from the TV speakers the
last time the TV was turned off.