Sony HT-CT350 Mode D'emploi page 51

Changing the display setting
(DISPLAY)
You can change the display behavior of the front
panel display.
1
Select "SYSTEM" in the AMP menu,
or c.
then press
2
Select " DISPLAY," then press
3
Select the setting and press
• ON: The display stays turned on.
• OFF: The display appears for a few
seconds when you operate the
system.
Tip
• The display shows the kinds of input signal (digital
input only) when you press DISPLAY, even if you set
"DISPLAY" to "OFF."
Note
• The display stays turned on when the muting or
protection function is working, even if you set
"DISPLAY" to "OFF."
Using the sleep timer (SLEEP)
You can set the system to turn off at a preset time
when you want to fall asleep listening to music.
You can preset the time in 10-minute increments.
1
Select "SYSTEM" in the AMP menu,
then press or c.
2
Select "SLEEP," then press
3
Select the preset time you want and
press .
The minutes display (remaining time)
changes as follows:
OFF y 10M y 20M
Y
90M y 80M ... 30M
Note
• This function is only for this system, not for the
connected TV or other components.
or c.
.
or c.
Y
Auto Standby function (AUTO
STBY)
You can reduce power consumption. The system
enters standby mode automatically when you do
not operate the system for about 30 minutes and
the system is not outputting sound for about 30
minutes.
The default setting is "ON".
1
Select "SYSTEM" in the AMP menu,
or c.
then press
2
Select "AUTO STBY," then press
c.
3
Select the setting and press
• ON: Turns on the "AUTO STBY"
function.
• OFF: Turns off the function.
Notes
• When the system is turned off via the AUTO STBY
function, the system may not be turned on
automatically when you turn on the TV next time.
• "AUTO STBY" begins to flash in the front panel
display about two minutes before the system enters
standby mode.
or
.
51
US