Connecting The Fm Wire Antenna (Aerial); Connecting The Ac Power Cord (Mains Lead); Setting Up The Sound Output Of The Connected Component - Sony HT-CT350 Mode D'emploi

Connecting the FM wire antenna (aerial)

Connect the FM wire antenna (aerial) to the FM 75 Ω COAXIAL jack.
Rear of the
subwoofer
BD IN
ONLY FOR
SS-CT350
Notes
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep it as horizontal as possible.
• Do not use the FM wire antenna (aerial) while it is bundled up.
• Insert the FM wire antenna (aerial) fully and firmly to the terminal.
Tip
• If you have poor FM reception, use a 75-ohm coaxial cable (not supplied) to connect the subwoofer to an outdoor
FM antenna (aerial) as shown below.
Rear of the
subwoofer

Connecting the AC power cord (mains lead)

Before connecting the AC power cord (mains lead) of the system to a wall outlet (mains), connect all
the other components and TV to the system.
Notes
• After connecting the AC power cord (mains lead), wait about 20 seconds before turning on the power by pressing
?/1.
• Connect the system to an easily accessible AC outlet (mains). Should you notice an abnormality in the system,
disconnect the main plug from the AC outlet (mains) immediately.

Setting up the sound output of the connected component

To enjoy sound in multi-channel format (DTS, Dolby Digital, multi-channel LPCM), you need to make
the audio output settings of the connected component. Set the connected component to output sound in
multi-channel format. For details on audio output settings, refer to the operating instructions supplied
with the connected component.
L
ANTENNA
R
FM
AUDIO IN AUDIO IN
75 COAXIAL
AM
SA-CD/CD TV
HDMI
ARC
SAT/CATV IN TV OUT
DIGITAL
OPT IN COAX IN
SAT/CATV TV VIDEO
ANTENNA
FM
75 COAXIAL AM
FM 75 Ω COAXIAL jack
FM wire antenna
(aerial)
(supplied)
Outdoor FM antenna
(aerial)
27
US