Converting To Top Feed; Converting The Gun From Non-Bleeder To Bleeder - Titan Maxum Elite Notice D'utilisation

Converting to Top Feed

The cup is designed for a maximum working pressure
of 6 PSI (0.41 bar). Pressures higher than 6 psi can
result in cup leakage, damage to the equipment, and/
or potential injury to the user.
The top feed HVLP spray gun is designed for use in special
applications such as spraying in confined areas. The position of
the cup gives the top feed gun the ability to spray downward and
overhead. When spraying with the top feed gun, remember the
following tips for the best results. Keep the cup pressurized at all
times when spraying. Attempting to gravity feed the material will
slow or stop the flow of material at the nozzle.
NOTE: It is recommended that the gun hook be removed
whenever using the top feed cup assembly.
To set up the spray gun for top feed delivery:
1. Loosen the retaining nut using a wrench and remove the one
quart cup assembly.
2. Pull the air tube off of the air tube fitting on the spray gun.
3. Separate the gun head from the gun rear (see instructions
on page 3). Reassemble gun head upside-down so fluid inlet
fitting on gun head points upward to accept the top feed cup
assembly.
4. Remove the gun hook and thread the retaining nut of the top-
feed cup assembly onto the fluid inlet of the gun head. Rotate
the stand away from the cup and set the gun assembly on a
level surface.
5. Using an adjustable wrench, secure the retaining nut, making
sure the gun/cup assembly stays in a level position. The cup
should end up in a vertical position when supported by the
stand.
6. Connect the air tube to the air tube fitting on the spray gun.
IMPORTANT: The gun, when converted to top-feed, will not
stand on its own. Make sure to use the stand when filling. Do not
lay the gun on its side when it is filled with material. Do not hang
the gun by its hook when filled with material.
© Titan Tool Inc. All rights reserved.
Air tube
Air tube tting
Fluid inlet
Converting the gun from Non-Bleeder to
Bleeder
Your HVLP spray gun can be converted from a non-bleeder to a
bleeder setup. Bleeder setup provides more atomizing power for
higher viscosity materials, such as latex and enamels. Bleeder setup
can make it easier to spray in confined spaces, such as inside cabinets,
because the air hose is moved to the back of the gun.
To convert a spray gun to bleeder setup:
1. Remove the air flow adjustment knob from the rear of the gun
using a wrench.
2. Remove the air inlet fitting from the bottom of the gun handle
using a wrench.
3. Thread the air inlet fitting into the air flow adjustment knob
location at the rear of the gun. Secure the fitting in place.
Air ow
adjustment
knob
4. Thread the air inlet plug (shipped loose with the gun literature
pack) into the air inlet at the bottom of the gun handle.
Secure the plug in place.
Air inlet
plug
5. Attach the air hose to the relocated air inlet fitting.
NOTE: In bleeder setup, the removal of the air flow
adjustment knob causes the air supply to be on at all
times when the air hose is attached to the gun.
9
Air inlet
tting
English