Service; Introduction; Split Design - Titan Maxum Elite Notice D'utilisation

Service

Should your HVLP spray gun need service during the warranty period,
return the unit and the proof of purchase to the distributor where it
was purchased. At our option, the unit will be repaired or replaced. In
a continued commitment to improve quality, we reserve the right to
make component or design changes when necessary.

Introduction

These spray guns are designed for use in a High Volume/Low Pressure
(HVLP) painting system.
With an HVLP system, the highest quality professional finish can be
achieved with little preparation or setup time. HVLP systems are
not intended to replace airless systems. Instead, they are meant to
compliment airless by improving the final finish on the substrate,
minimizing waste, and reducing labor time. In addition to enhancing
profitability, HVLP systems are compliant with the most stringent
transfer efficiency requirements.
The HVLP spray guns described in this manual include the turbine
cup gun and the turbine top feed gun. Please review all the
information contained in this manual before operating an HVLP
system.
NOTE: The general operation and maintenance of each style
of HVLP spray gun are the same. For illustration
purposes, the turbine cup gun is pictured. However,
any information specific to a style of gun is described
where necessary. A parts listing for each style of gun
is included near the back of this manual.
Air flow
adj. knob
Material flow
adj. knob
Trigger
release
Packing nut
Trigger
Check valve
Air Inlet
NOTE: The hook on top of the gun body can be easily
removed or reversed. Slide the hook toward the rear
of the gun to remove it.
© Titan Tool Inc. All rights reserved.

Split Design

This HVLP spray gun has a split-gun design that allows for easier
cleaning and disassembly. The two sections are the gun head and
gun rear.
Gun rear
To separate the two halves of the HVLP spray gun, follow the steps
below.
1. Make sure the air hose is removed from the air inlet of the
spray gun.
2. Swivel the trigger releases on
both sides of the spray gun so
they are pointing up.
3. Push the lever toward the rear of
the gun to unlock the two gun
halves.
4. While looking at the rear of the
spray gun, turn the gun rear counterclockwise to remove it
from the gun head.
Hook
Lever
Air cap ring
Air cap
Fluid inlet
Cup locking
lever
1-Quart cup
assembly
NOTE: The needle will remain inside the gun head. Be sure
not to remove unless instructed.
To join the two halves of the HVLP spray gun, follow the steps below.
1. Make sure the trigger releases on both sides of the spray gun
Swivel tube are pointing up (toward the gun hook).
lever
2. With the gun rear oriented upside down, bring the two halves
together. While looking at the rear of the spray gun, turn the
trigger section clockwise until it snaps back into place with the
gun head.
3. Swivel the trigger releases on both sides of the spray gun so
that they are pointing toward the gun head.
3
Gun head
Needle
English