Publicité
Les langues disponibles
Les langues disponibles
3 Assembly
Quick-release Seat Clamp
❶ Unlock the quick-release lever and insert the seat post into
the seat tube. Figure 3.15
❷ Adjust the seat height up or down until the rider feels they
have control of the bicycle and is comfortable.
Important! Be sure the minimum insertion marks do not go
past the top of the seat clamp and are not visible. See
Section 1, Fig. 1.2: Seat Height and Handlebar Reach.
❸ Close the quick-release lever and lock the seat in place.
If there is not enough pressure to hold the seat in place
open the quick-release lever. With one hand on the quick-
release lever and one hand on the adjustment nut, start to
hand tighten the adjustment nut until you start to feel some
resistance against the seat post clamp. Do not attempt to
tighten by turning the quick-release lever. The quick-release
lever is for closing, the adjustment nut is for adjusting the
pressure. Figure 3.16
❹ Try to close the quick-release lever. If it closes easily, open it
up and tighten the adjustment nut further. If it is too
difficult to close, open the quick-release lever up and loosen
the adjustment nut a little and try again.
Important! You should feel resistance when you close
the quick-release lever that should leave a temporary
impression on your fingers. Open and close the handle to
ensure the seat is securely locked in place.
26
Seat post
Minimum insertion marks
on the seat post
Adjustment nut
Quick-release lever
3
2
Quick-release
seat clamp
1
Seat tube
Figure 3.15
Minimum
insertion
marks
Figure 3.16
Publicité
