ATH-Heinl ATH-W Mode D'emploi page 94

2.9.12. Service calibration of the gauge in car mode
Position the gauge to "0"
Press the key combination STOP + < 5 g
The display shown opposite will appear
+
Position the gauge to "100 mm"
Press the ALU button
The display shows [CAL] – [300]
Position the gauge to "300 mm". When doing so, position the
measuring tip to the outer edge of the entry cover.
Press the ALU button
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2022-07
Manufacturer ATH-Heinl GmbH & CO.KG
- 33 -