ATH-Heinl ATH-W Mode D'emploi page 88

2.9.6.
Remove the fixing screw on the side of the
wheel lift.
Slide the access ramp onto the screw from the
front.
Then secure the ramp using the screw.
2.9.7.
The basic settings can be established using the system settings.
Display unit for the imbalance grams / ounces
Automatic start when closing the wheel protector on/off
Calibration programme for the automatic gauge (2D)
Calibration programme
HID programme
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2022-07
Assembling the access ramp
System settings
Manufacturer ATH-Heinl GmbH & CO.KG
- 27 -
+
+
+
+
+