ATH-Heinl ATH-W Mode D'emploi page 73

After the balancing process, the HID programme
can be selected by pressing the T + MODEL
+
buttons
The display then shows SPO – 12H.
Turn the wheel until all the diodes on the display
for the external position light up.
Now confirm this position using ALU
The display will then show SPO – -1-.
Now turn the wheel until the left spoke is at the 12
o'clock position.
Now confirm this position using ALU
The display will then show SPO – -2-.
Now turn the wheel until the right spoke is at the
12 o'clock position.
Now confirm this position using ALU
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2022-07
Manufacturer ATH-Heinl GmbH & CO.KG
- 12 -