ATH-Heinl ATH-W Mode D'emploi page 81

Cone 45-71 mm
Cone 69-91 mm
Cone 89-114 mm
Cone 107-133 mm
Cone 96-149 mm
Cone 141-170 mm
Cone 169-214 mm
Small distance ring
Large distance ring
Compression spring
Lorry clamping nut
Car rapid clamping nut
Tensioned cover
Rubber lip for tensioned cover
Universal flange for truck 3/4/5-hole
2.4 Location
The machine should be kept away from flammable and explosive materials, as well as from sunlight and
intense light. The machine should be placed in a well-ventilated location.
The machine must be set up on sufficiently firm ground, if necessary, according to the minimum
requirements of the information given in the foundation plan.
In addition to the ground conditions, the guidelines and instructions of the accident prevention regulations
as well as the workplace regulations must be observed when selecting an installation site.
When assembling on floor coverings, check their load-bearing capacity. A construction expert should be
consulted for inspection when mounting on floor coverings.
The machine should only be mounted and used within closed rooms. It has no corresponding safety
features (e.g. IP protection, galvanised design, etc.).
Temperature
Sea level
Humidity
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2022-07
4-40 °C
< 1500 m
50% at 40 °C – 90% at 20 °C
Manufacturer ATH-Heinl GmbH & CO.KG
- 20 -