Automatic Defrost - EUROM Polar 12C Mode D'emploi

Timer
The device can automatically start and stop at a preset time.
Automatically start
1. Set the device in the desired mode and the desired temperature.
2. Press the ON/OFF button, the device is now in standby mode.
3. Press the Timer button.
4. Use the Up and Down button(s) to set the countdown timer the device will automatically
start. (1-24 hours)
5. Press the Timer button, the display shows the selected time until the device starts.
Automatically stop
1. Set the device in the desired mode and the desired temperature.
2. Press the Timer button.
3. Use the Up and Down button(s) to set the countdown timer the device will automatically
stop. (1-24 hours)
4. Press the Timer button, the display shows the selected time until the device stops.
Deactivate automatic timer
1. Press the Up and Down button(s) simultaneously repeatedly until the display shows '00'.
Pressing the Power button exits the Timer setting.
Drainage of condensed water
The device extracts water from the air. The water is partially evaporated with the discharge of
the warm air. The remaining water accumulates in the water tank. When the tank is full the
device stops automatically and the message Ft will appear on the display.
1. Make sure the device is switched off and the
plug is removed from the power outlet
(Figure 16, pos. 2).
2. Remove the cap from the water discharge
point (Figure 16, pos. 2), drain the tank in a
container or a well.
3. Don't forget to put the cap back on the water
discharge point.

Automatic defrost

The device is operating in the cooling or dehumidify mode and the built-in temperature
sensor detects that the temperature is lower than -1°C frost is detected.
The compressor will stop temporarily and the device starts to defrost automatically and
indicator lights start blinking.
After the temperature has risen sufficiently, the compressor will start working automatically.
Figure 16
27