Cooling Mode - EUROM Polar 12C Mode D'emploi

Operation
WARNING
Before every use, make sure that:
•
you operate the device with dry hands;
•
the device is clean and dry;
•
the device is not damaged;
•
the device is not covered or blocked;
•
the device stands securely and horizontally.
1. Make sure the device is correctly installed.
2. Press the ON/OFF button on the device (Figure 4, pos. 1) or the remote control (Figure 5,
pos. 12). The device will start in Fan mode.
3. Press the Mode button on the device (Figure 4, pos. 2) or the Heat, Fan, Dehumidify or
Cool button on the remote control (Figure 5, pos. 2, 9, 10, 11) to select the desired
mode. (Heat mode is only available on the Polar 16CH).
Fan mode
1. Press the Speed button to select the desired fan speed (Low-Medium-High).
2. If desired, press the Swing button to activate or deactivate the swing motion.

Cooling mode

1. Press the Up and Down button(s) to set the required temperature (16 °C-32 °C).
2. Press the Speed button to select the desired fan speed (Low-Medium-High).
3. If desired, press the Swing button to activate or deactivate the swing motion.
4. The device will stop cooling when the ambient temperature is lower than the required
temperature.
Heating mode
(Polar 16CH only)
1. Press the Up and Down button(s) to set the required temperature (16 °C-32 °C).
2. Press the Speed button to select the desired fan speed (Low-Medium-High).
3. If desired, press the Swing button to activate or deactivate the swing motion.
4. The device will stop heating when the ambient temperature is higher than the required
temperature.
If heating for a longer period, install the water drain hose (Figure 14).
Dehumidify mode
1. Follow the instructions for 'Installation to dehumidify' before choosing this mode.
2. Regularly check the water level in the bucket the end of the hose should not be
immersed in water.
3. If desired, press the Swing button to activate or deactivate the swing motion.
Sleep mode
1. Press the Sleep button, can only be activated in Cooling mode, to activate sleep mode.
After 1 hour of cooling, the required temperature is automatically increased by 1 degree.
After another hour of cooling, the required temperature is again automatically increased
by 1 degree.
26