Technoline WS1700 Mode D'emploi page 38


Press "MODE" to switch to "Time display" mode.

Press "DOWN" to switch to 1Hour, press again to 24 Hour, then Total wind speed and
rainfall

Press and hold "DOWN" to clear up the volume accordingly, such as if showing 1 hour,
clear up the data in 1 hour, others unchanged, if showing 24 hours, clear up the data in 24
hour, others unchanged.

The max. of the rainfall is up to 999.99mm (99.99inch), the display is flashing in case of
the max., you have to clear up the data by hand, otherwise, the data can not be updated
any more.
Weather forecast
Sunny Slightly Sunny
Remarks：

As the weather forecast is calculated by air pressure only, the display will have
discrepancy with the actual weather.

Currently displayed icon means the forecast for the next 12–24 hours. It may not reflect
the current state of the weather.
Altitude setting and barometer

After inserting batteries or plugged in adaptor into the weather station, or by pressing
and holding the "SNOOZE/LIHGT" button, set your altitude for more precise pressure
calculation.

Use the "UP" and "DOWN" buttons to set a value in the range -190 m to 2000 m (10
m increment). , press "SNOOZE/LIHGT" to confirm.

After setting the altitude, use "UP" and "DOWN" buttons to set the weather forecast
icon, press "SNOOZE/LIHGT" to confirm

For accurate barometric pressure trends, the weather station should operate at the
same altitude for recordings (i.e. it should not be moved from the ground to the second
floor of the house). When the unit is moved to a new location, discard readings for the
next 12 hours and correct the height adjustment (see "Initial operation") if needed.
Temperature, humidity and pressure trends

The arrow shows the trends of values of the temperature and humidity measurements on
sensor or station.
Cloudy Rainy Heavy Rain