Technoline WS1700 Mode D'emploi page 37


When the temperature reach the set alert level and when alert turned on, the alert symbol
flash with alert sound

Press any key to stop the alert sound, the alert symbol and corresponding temperature still
flash until the temperature is out of alert range

Or Press "MODE" to switch to the "Temperature alert mode", press and hold the "MODE"
key to enter setup, then press "UP" or "DOWN" to deactivate the alert
12/24 hours mode

The time display can be in 12（AM/PM）or 24 hours mode, please follow the "Manual
set-up" section to select
°C/°F temperature display

The temperature display can be in °C or °F, please follow the "Manual set-up" section to
select.
Max. / Min. for the indoor/outdoor temperature and humidity

Press "MODE" to switch to "Time display" / "Indoor temperature alert" / "Outdoor
temperature alert" mode

Press "UP" to display indoor and outdoor max temperature and humidity,

Press "UP" again to display indoor and outdoor min temperature and humidity

Hold "UP" for more than 3 seconds to clear up the max./min.
Wind speed in mph/kmh (0~256kmh)

The wind speed can be shown in mph and kmh, please follow the "Manual set-up"
section to select mph/kmh, the display of the speed is updated in case of the sensor
updated every 1 minute.
Wind direction

There will be 16 wind directions, the display of the direction is updated in case of the
sensor updated every 1 minutes
Rainfall display ( 0~999.99mm)

Rain fall can be shown in mm and inch, please follow the "Manual set-up" section to
select the mm/inch.