Technoline WS1700 Mode D'emploi page 27

Getting Started with Power Supply
Insert batteries:
1. Gently remove the stand downwards and remove battery compartment cover from the main
unit.
2. Insert 2 x AA Mignon batteries, matching the polarities (+/-).
DC Power:
1. Put the power cable pass through the hole in the stand, plug the power cable to the
power jack and plug the power adapter into a suitable power outlet.
NOTE
It is recommended to insert the battery as backup for regular dc power.
Outdoor sensor
1. Pull away the radiation shield off the thermo-hygro sensor to reveal the 2 sockets for
the wind sensor and rain sensor.
2. Open the thermo-hygro sensor battery door, insert 2 x AA Mignon batteries, matching
the polarities (+/-).
Note: To prevent water from entering the sensor, it is important to make sure the
battery lid closes tightly.