Technoline WS1700 Mode D'emploi page 33


This process takes about 3 minutes. Then the display shows the outdoor temperature
/humidity/wind speed/wind direction/rainfall, in case of failure of reception , please press
"OUT" for more than 3 seconds to receive again.

The automatic receiving of the DCF77 radio signal begins after 3 minutes of outdoor RF
reception.

This RCC reception process is going on,the flashing symbol "radio tower" appears in the
time display area at the same time.

Once radio signal receiving is successful, the display shows the symbol "radio
tower" continuously
Reception of radio controlled signal

DCF77 radio signal search starts automatically about 3 minutes after battery exchange.
The "radio tower"

Press "IN" for more than 3 seconds to enter or quit the Radio controlled signal reception

Flashing "radio tower"

Continuous "radio tower"
successful.

If the synchronization is unsuccessful, the "radio tower"

The clock synchronizes with the DCF77 radio signal automatically and daily from 1:00AM
to 3:00AM to correct potential time deviations each hour. If the reception is unsuccessful,
a further synchronization attempt is made at 4:00AM and 5:00AM until success. If it is still
not success at 5:00AM, the daily reception will stop.
Information

Please observe a minimal distance of 2.5m to sources of interference such as televisions
or computer screens.

The radio signal is weaker in rooms with concrete walls (e.g. in the basement) and in
office buildings. For extreme cases, please put the main unit near a window.

There are less atmospheric disturbances at night. A radio time signal reception is usually
possible at that time. One synchronization per day is sufficient to keep the time display
accuracy at 1 second.
signal is flashing.
symbol stands for DCF77 radio signal reception started.
symbol stands for DCF77 radio signal reception
symbol disappears.