Technoline WS1700 Mode D'emploi page 32

So that data can be transmitted to the main unit, then put the radiation shield onto the
thermo-hygro sensor, please follow the below display:
Note: please don't put in or take off the plug very often,or put the plug outside in the
air so long time to avoid any damage of the plug , as this can result in bad
connection.
6) Mounting all the sensors onto the stainless steel mast and fix the whole parts at
outdoor open area (please refer to the illustration above)
Note: please make sure all the cables are connected well into the sockets)
Attention!! Ensure that the outdoor sensor can be received from the base station at its
intended location before the final installation of the outdoor sensor takes place at its
final location.
Initial Operation

After inserting the batteries, the altitude flashing in meters, press "UP " or "DOWN " to
set the altitude of your position, then press "SNOOZE/LIGHT" to confirm

The weather icon flashing, press "UP " or "DOWN " to choose the weather, then
press "SNOOZE/LIGHT" to confirm

The main unit will connect with the outdoor sensor by RF signal.
The RF signal symbol at the out area will flash.